Perfect upgrade for the original Raise3D E2 hotend

Suitable for: Raise3D E2/Pro3 (mountable on both sides)

Scope of delivery:

1x Timeslicer Heatblock incl. Heatbreak (pre-assembled)
1x 04mm CHT Nozzle
1x 0.8mm CHT Nozzle
1x 0.6mm Ruby / Sapphire Nozzle
1x tool set

The smart Plug&Play alternative to the original hotend

The 3DSolex Timeslicer upgrade hotend has been specially developed and optimized for the 1to1 replacement of Raise3D hotends of the E2 series.

Two sets are available:

Standard with a 0.40mm and a 0.80mm core heating nozzle for up to 4 times more filament flow compared to the normal hotend

Premium with an additional 0.60mm Ruby Everlast nozzle, which is specially designed for the permanent use of fiber-reinforced filaments.

The upgrade hotends use the original cartridge heater and the original temperature sensor. In contrast to products from other manufacturers, nothing has to be changed on the sensitive electronics.

When it comes to nozzles, 3DSolex offers a large selection of standard, special nozzles and special sizes. Now also with CHT - Core Heating Technology - thanks to which up to 4x more plastic can be melted in the same amount of time. This enables unprecedented printing speeds.

Standard nozzles:

0.25 / 0.40 / 0.60 / 0.80 / 1.00mm (very similar to the Raise3D offering)

Special nozzles with ruby ​​insert for fiber-filled materials:

0.25 / 0.40 / 0.50 / 0.60 / 0.80 / 1.20mm

special sizes:

0.10 / 0.15 / 1.50mm

Of course, this large selection gives you even more flexibility.

You can also print extremely fine structures with the small nozzles, achieve higher speeds with the large nozzles and use fiber-filled filaments permanently with the Ruby nozzles.

The advantages at a glance:

• Upgrade hotends can be exchanged 1:1 for Raise3D products (Plug&Play)
• CHT enables significantly higher melting performance and thus higher printing speeds
• Significantly improved heat break, so no more risk of filament jams between the hotend and the filament feed
• Optimized cooling, so permanently high operating temperatures can be implemented
• Nozzles can be replaced more easily
• Large selection of nozzles
• Made in Norway, highest quality of components and final assembly
• The temperature distribution is more even
• Identical height as the original hotend, so exchanging a single hotend is not a problem
• Simple nozzle exchange as brass (nozzle) is screwed into brass (block).