The Raise3D steel nozzle is made of hardened steel with a special coating for lower friction values and higher abrasion resistance
Short info:
Characteristics:
abrasion resistance
high temperature resistance
Lower coefficient of friction than 0.03 with WS2 coating
Chemical properties: non-toxic, non-caustic and insoluble
Good smear and abrasion resistance at the highest temperature up to 450°C.
Material properties:
The nozzle is not only suitable for ordinary filaments, but also especially for composite filaments with abrasive additives such as carbon fiber, steel, wood, boron carbide, tungsten, phosphorescent pigment, etc. and such high temperature resistant filaments.
Instructions:
For the Pro2 series:
Instructions for replacing and installing the hot ends. Click here.
Instructions for replacing the nozzles. Click here.
For E2:
Instructions for replacing the hot ends. Click here.
Instructions for replacing the nozzles. Click here.
Please note: Nozzles can only be changed after unloading the filament and when hot. Wear gloves to do this.