3DSolex Timeslicer upgrade hotend in the standard set

Suitable for: Raise3D E2/Pro3 (can be mounted on both sides)

The smart Plug&Play alternative to the original Hotend

The 3DSolex Timeslicer upgrade hotend has been specially developed and optimized for the 1:1 replacement of Raise3D hotends of the E2 series.

Two sets are available:

Standard with a 0.40mm and a 0.80mm core heating nozzle for up to 4 times more filament flow compared to the normal hotend

Premium with an additional 0.60mm Ruby Everlast nozzle, which is specially designed for the long-term use of fiber-reinforced filaments.

Scope of delivery:

1x Timeslicer Heatblock incl. Heatbreak (pre-assembled)
1x 04mm CHT Nozzle
1x 0.8mm CHT Nozzle
1x tool set

The upgrade hotends use the original heating cartridge and the original temperature sensor. This means that nothing needs to be changed on the sensitive electronics, unlike products from other manufacturers.

When it comes to nozzles, 3DSolex offers a large selection of standard, special and special sizes. Now also with CHT - Core Heating Technology - thanks to which up to 4x more plastic can be melted in the same amount of time. This enables previously unattainable printing speeds.

Standard nozzles:

0.25 / 0.40 / 0.60 / 0.80 / 1.00 mm (very similar to Raise3D offer)

Special nozzles with ruby ​​insert for fiber-filled materials:

0.25/0.40/0.50/0.60/0.80/1.20mm

Special sizes:

0.10 / 0.15 / 1.50mm

This large selection naturally gives you even more flexibility.

This means you can print extremely fine structures with the small nozzles, achieve higher speeds with the large nozzles and use fiber-filled filaments permanently with the Ruby nozzles.

The advantages at a glance:

• Upgrade hotends can be exchanged 1:1 for Raise3D products (Plug&Play)
• CHT enables significantly higher melting performance and therefore higher printing speeds
• Significantly improved heat break, thus no more risk of filament jams between the hotend and the filament feed
• Optimized cooling, thus permanently high operating temperatures can be achieved
• Nozzles can be replaced more easily
• Large selection of nozzles
• Made in Norway, highest quality components and final assembly
• The temperature distribution is more even
• Identical height as the original hotend, so replacing a single hotend is no problem
• Easy nozzle replacement as brass (nozzle) is screwed into brass (block)