Raise3D steel nozzle with WS2 coating

Specially coated original nozzle from Raise3D.

The Raise3D steel nozzle is made of hardened steel with a special coating for lower friction values ​​and higher abrasion resistance

Short info:

• Suitable for: Raise3D Pro2, Raise3D Pro2 Plus, Raise3D E2
• Diameter: 0.4/0.6/0.8mm
• 0.4mm diameter also suitable for the Raise3D Pro3 and Raise3D Pro3 Plus

Characteristics:

• Abrasion resistance

• High temperature resistance

• Lower friction coefficient than 0.03 with WS2 coating

• Chemical properties: non-toxic, non-corrosive and insoluble

• Good lubrication and abrasion resistance at highest temperatures up to 450 ° C.

• Very good filament flow

Material properties:

• Mohs hardness: 7.8
• Max. Pressure Temp: 450°C
• Thermal conductivity: 26W/mk
• CTE: 12μm/m. °C

The nozzle is not only suitable for normal filaments, but also especially for composite filaments with abrasive additives such as carbon fiber, steel, wood, boron carbide, tungsten, phosphorescent pigment, etc. and those high temperature resistant filaments.

Instructions:

For the Pro2 series:

Instructions on how to replace and install the hot ends. Click here.

Instructions on how to replace the nozzles. Click here.

For E2:

Instructions on how to replace the hot ends. Click here.

Instructions on how to replace the nozzles. Click here.

Please note: Nozzles can only be changed after the filament has been unloaded and when the nozzle is hot. Wear gloves when doing this.