![PolyMaker Polysher - [3dmaterial-shop]](http://3dmaterial-shop.de/cdn/shop/products/Polysher_-Polymaker.png?v=1660780296&width=1080)
![PolyMaker Polysher - [3dmaterial-shop]](http://3dmaterial-shop.de/cdn/shop/products/Polysher_-Polymaker_1800x1800.png?v=1660780296)
PolyMaker Polysher
Smooths and finishes 3D prints without toxic fumes.
This is how you easily get perfectly smooth and clean 3D models.
The prerequisite for this is the use of PolySmooth 3D filament and the subsequent finishing of the prints with the Polysher.
Unlike well-known systems with acetone and ABS, the Polysher does not release any toxic fumes. This system creates a fine mist of alcohol. The alcohol smooths out the special filament and as soon as it sinks to the bottom and becomes liquid again, the polysher takes it back into its tank. Furthermore, the system is completely closed. This means that the alcohol mist cannot escape.
Scope of delivery:
- Polysher hardware
- 2 pieces evaporator
- 2 pieces plates for models (150mm diameter)
- printed instructions
- pipette
- Cable
technology
Atomized aerosol polishing
Compatible material
PolySmooth™
polishing liquid
Isopropanol or Ethanol, 70% or greater [90% or greater is recommended]
polishing time
typically 10 – 30 min (depending on the size of the print)
product dimension
230x270x370mm
Maximum part size that can be polished
150 mm (diameter) x 180 mm (height) cylinder [5.9 in (diameter) x 7.1 in (height)]
operating temperatur
15 - 32°C
storage temperature
0 - 38 °C
energy demand
100-240V, 2A max, 50/60Hz
Attention: You need alcohol with at least 70% concentration. This is not included in the scope of delivery. 1 liter is quite sufficient for several models.
